The ending of a word; a final syllable or letter; the part added to a stem in inflection.
The formal ending of a reinsurance agreement by its natural expiry, cancellation or commutation by the parties. Terminations can be either on a cutoff or runoff basis. Under cutoff provisions, the parties' obligations are fixed as of the agreed cutoff date. Otherwise, obligations incurred while the agreement was in force are run off to their natural extinction.
A procedure used to electrically end a SCSI cable and prevent reflections. Passive termination is provided by resistors on the end of the cable. Active termination controls the impedance of the cable to provide better signals. Both types absorb the signal at the end of the cable, preventing it from bouncing back and causing noise.
Because of the amount of signals that SCSI format sends through small wiring, termination is required. The termination is accomplished by using resistors...
The discontinuance of eligibility and payment or the ending of a period of suspension without reinstatement. See: Change of Circumstances
1. A load or impedance at the end of a cable or signal line used to match the impedance of the equipment that generated the signal. The impedance absorbs signal energy to prevent signal reflections from going back toward the source. For video signals, termination impedance is typically 75 ohms; for sync signals, it is usually 510 ohms. 2. A connector at the end of a cable.
The end of an employment relationship for any reason other than death or retirement. Members who terminate employment may have be eligible to receive an immediate pension, a deferred pension, a Commuted Value transfer or a refund of their contributions and interest, depending on their age and years of Pensionable Service.
The video cable requires an impedance of 75 ohms at normal video signal bandwidth. This is often called 'low Z'. There is a switch on the back of the monitors to select either 75 ohm or 'high Z' (sometimes 'high/low'). If a signal is looped through more than one monitor all should be set to 'high' except at last, which should be to 'low' or 75 ohm.
When a pension plan ends.
Connecting an impedance device (such as a resistor) to the end of a circuit to prevent signal reflections or echoes.
(1) Item such as a port that is connected to the end point of a circuit or equipment. (2) The points on a switching network to which a trunk or line may be attached.
The act of ending or concluding. In psychotherapy, termination refers to the mutual agreement between patient and therapist to bring therapy to an end. The idea of termination often occurs to both, but usually it is the therapist who introduces the subject into the session as a possibility to be considered. In psychoanalytic treatment, the patient's reactions are worked through to completion before the treatment ends. The early termination that is characteristic of focal psychotherapy and other forms of brief psychotherapy often requires more extensive work with the feelings of loss and separation.
The dissolution of a contract, agreement, instrument, or lease.Usually, a termination anticipates the end of a term.It can be decided on by both parties of an agreement or may be brought about by one party or by a court or legal action.
The end of something, usually refers to contracts• Contracts
The end of a crystal face, usually referring to its base.
The process of installing a connector onto a fiber or copper cable.
The electrical connection required at each end of the SCSI bus, composed of a set of resistors.
The process of connectorizing one or both ends of a fiber or cable.
The employee-employer relationship ends between a WRS participant and the WRS employer.
The scheduled termination is the end of the lease term as called for in the lease.
a coming to an end of a contract period; "the expiry of his driver's license"
a place where something ends or is complete
the end of a word (a suffix or inflectional ending or final morpheme); "I don't like words that have -ism as an ending"
the act of ending something; "the termination of the agreement"
a request to end participation in a dividend reinvestment plan account
Not what happens when Arnie comes to your door saying "Sarah Conner. . . where is she?", but instead this is the term used for when you or your landlord decide to end the tenancy.
A load used to terminate an output circuit, customarily in its characteristic impedance, to avert damage or unexpected operation.
The act of ending the employee/employer contract by either the giving of notice, instant dismissal, resignation or frustration of contract.
The end of a crystal, preferably with faces. Unterminated crystals are undesirable.
The ending of employment by employers or employees. State and federal laws regulate the termination of employment. See the Termination of Employment section for more information.
The end of foster care placement
A buyer's right to end a contract for a serious breach committed by the seller. The buyer rejects the goods and in return gets a refund. In addition, a buyer may be entitled to damages.
The act of ending an employee's employment for any reason.
1). The load connected to the output end of a transmission line. 2). The provisions for ending a transmission line and connecting to a bus bar or other terminating device.
this is when either party decides to end the tenancy agreement, for example, if you give notice to move out or the landlord gives you notice to leave. The agreement does not actually end (terminate) until the tenant moves out or the Consumer, Trader and Tenancy Tribunal makes an order of termination.
in a chain growth polymerization, the reaction that causes the growing chain to stop growing. Termination reactions are reactions in which none of the products may react to make a polymer grow.
This usually refers to the physical act of terminating a cable with a special connector, which for coaxial cable is usually BNC. For fiber optic cable this is the ST connector. It can also refer to the impedance matching when electrical transmission is in use. This is especially important for high frequency signals, such as the video signal, where the characteristic impedance is accepted to be 75-W.
Placement of a connector on a cable or distribution panel. The presence of an electrical load at the end of a circuit equal to the characteristic line impedance of the physical medium being used to eliminate standing waves reflections during a transmission signal.
The end of translation; occurs when the ribosome reaches the stop codon on the messenger RNA molecule and the polypeptide, the messenger RNA, and the transfer RNA molecule are released from the ribosome.
completion of the project, either upon formal acceptance of its deliverables by the client and/or the disposal of such deliverables at the end of their life
Both ends of the main network bus must be terminated to avoid transmission reflections. The effective network data bus may be made up of several different physical buses. The Terminator is a RC circuit that matches the impedance of the physical media.
The ending of the employer/employee relationship. Terminations may be voluntary, initiated by the employee to pursue another opportunity. Terminations may also be involuntary, initiated by the employer for economic, disciplinary, or other reasons.
The process of ending an agreement.
A feature that stops the data signal at the beginning and the end of the SCSI bus. The first and last devices on the SCSI bus must be terminated.
The coming or bringing to an end of a lease, by mutual agreement, by the effluxion of time, or by the exercise of a right of one of the parties.
Terms used to refer to when a policy coverage ends.
the customer's option not to pay the rental fee causing the end of the agreement and necessitating the return of the merchandise. Also, to end an employee's employment with the business.
A load connected to the end of a transmission line. To avoid signal reflections, it must match the characteristic impedance of the line.
storage: A kind of electronic shock-absorber that goes at the beginning and end of a series of peripherals (external hard drives, scanners, etc.) that are connected to a SCSI port using a single cable path. The rule of thumb is that the first and last device in a SCSI chain must be terminated to prevent the data from echoing back upon itself and getting jumbled up. Hooking up a SCSI chain can be tricky. The computer has an internal terminator, so that takes care of one end of the chain. But some peripheral devices have an internal terminator (to be switched on and off) and some don't and sometimes you have to dismantle the case to find out. An external terminator that looks like a connector without any wires may be necessary. A worse problem is that sometimes you have to rearrange the SCSI devices and terminators until everything works. That should keep the techies in business. One vital hint: be sure to turn off the power before disconnecting or connecting anything
The date on which the dental benefits contract terminates or ends.
An impedance used to terminate a transmission line. For example; cables used for video distribution should be terminated with a 75 ohm resistor (terminator) at the last connector on the receiving end if it is not already terminated internally.
To send a signal through a transmission line accurately, there must be an impedance at the end which matches the impedance of the source and of the line itself. Amplitude errors, frequency response, and pulse distortions and reflections (ghosting) occur on a line without proper termination. Video is a 75Ohm system; therefore a 75Ohm terminator of .5% to .25% accuracy must be installed at the end of the signal path.
The cessation of premium paying for a Whole Life or Endowment policy before the agreed upon time. This ends the coverage, and the insured receives one of the nonforfeiture values. The cessation of a policy that does not or has not yet developed a cash value is termed a "lapse."
Completing a circuit by connecting a resistive load to it. A video signal is terminated by a 75 ohm resistive load. When there are looping inputs, any unused looping input must be terminated to ensure proper signal levels.
The term used to describe the end of line requirements for CCTV cable runs. In CCTV the termination is 75 ohms which corresponds to the characteristic impedance of the coax.
A method of matching the transmission impedance of a electrical bus so as to eliminate signal reflections from the physical ends of the bus.
This refers to a 75 Ohm terminator that is used to terminate each end of a video line.
A non-inductive resistor that has the same resistance as the characteristic of the cable being used.
Imposes an obligation on the tenant to return the property in a certain condition at the end of the lease.
The process of mechanically installing a connector onto a fibre cable.
Device used at the end of a rope to secure it to a vessel, anchor, buoy, structure, etc, or to join two lengths of rope. A knot is the simplest form, but greater efficiency is achieved with splices, resin sockets, or mechanical grips.
Some devices (such as the last device at each end of a SCSI cable) must be terminated to prevent reflections and spurious signals in the cable. When such devices are connected in a series, you may need to enable or disable the termination on these devices by changing jumper or switch settings on the devices or by changing settings in the configuration software for the devices.
The end of the lease term and completion of the lease.
the final stage of protein synthesis. A stop codon in conjunction with a releasing factor signals the ribosome to stop adding amino acids and release the peptide chain.
A term used in reference to impedance matching the end of cable runs by installing a non- inductive resistor having the same resistance value as the characteristic impedance value of the cable.
The time the coverage under an insurance policy ends, either because its term has expired or because it has been canceled by either party.
Preparation of the end of a fiber to allow connection to another fiber or an active device, sometimes also called "connectorization".
Termination is the act of attaching the fiber optic connector to the end of an optical fiber or fiber optic cable. Terminating an optical assembly with connectors allows for easy, repeatable use of the assembly in the field. Also called “connectorization.” See also: fiber optic connector, fiber, fiber optic cable
Completion of the project either on formal acceptance of the deliverables by the customer or SRO and/or the disposal of the deliverables at the end of their life
Termination is a formal process for ending a contractual relationship prior to its being completed without the mutual agreement of the vendor.There are two types of terminations – Termination for Convenience and Termination for Default. “Termination for Convenience” means the exercise of the right to completely or partially terminate performance of work under a contract when it is in MIT's interest. “Termination for Default” means the exercise of the right to completely or partially terminate a contract because of the contractor's actual or anticipated failure to perform its contractual obligations. Either type of termination is a formal process which requires the early involvement of the procurement office and may also involve the legal office.Procurement should be contacted as early as possible to determine the proper method to proceed.
A provider contract clause that describes how and under what circumstances the parties may end the contract. Termination of a policy upon the policy owner's failure to pay the premium within the grace period.
The ending of a pregnancy by choice by induced labor (resulting in a live birth or stillbirth) or abortion. See Abortion.
End of a lease or contract, usually before the anticipated time; termination may be by mutual agreement or by exercise of one party of a legal remedy due to default of the other party.